|
Depending on the agent, levels of protection may vary from mask only to full chemical protective suit. Currently the military uses the following: |
|
Gas masks were
issued by the government at the start of World War Two. Gas attacks were greatly
feared and all British citizens received a gas mask - including young children
and babies. Knowing how to maintain your gas mask led the government into
producing an information leaflet that explained how this could be done
successfully so that the masks worked in the event of an attack.
This document is set out below.
Take care of your gas mask and your gas mask will take care of you.
It is possible that in war your life might depend on your gas mask and the condition in which it had been kept.
The official gas mask, or respirator, consists of a metal container filled with material, which absorbs
the gas, and a rubber face piece with a non-inflammable transparent window. Some
people seem to think that this mask does not look as if it would offer very good
protection. Actually, it has been most carefully designed and fully tested, and
will give you adequate protection against any of the known war gases. But
remember it will not protect you from the ordinary gas that you burn in a gas
cooker or gas fire.
How to store it:
How to put it on and take it off:
NEVER TRY TO LIFT THE MASK OFF UPWARDS OR BY PULLING THE CONTAINER OR THE EDGE OF THE RUBBER AT THE CHIN.
To prevent the window from misting over when the mask is worn, wet the end of a finger and rub it on a
piece of toilet soap. Then rub the finger all over the inside of the window so as to leave a thin film of soap.
Putting your mask away:
Your mask should be kept carefully. Never hang it up by the straps which fasten it on over the head. This
will pull the rubber face piece out of shape so that it no longer fits you
properly. It should be kept in the special box provided, where this has been
issued, but any box which is air tight, or nearly so, will do.
When placed in the box the metal container should lie flat with the rubber face piece uppermost, the
transparent window lying evenly on top at full length. Great care should be
taken not to bend or fold the window, or let it get scratched, cracked or dented.
Keep the box in a cool place
away from strong light. Exposure to heat or prolonged exposure to strong light
will spoil the material of the mask and it may cease to give complete
protection. It should never be held close to a fire or hot water pipes, or left
lying out in the sun.
It is important to know how to put on your mask quickly and properly. You might need to do this in a hurry. To
put it on, hold the mask by each of the side straps with the thumbs underneath
and the inside of the window facing you. Then lift the mask to your face, push
your chin forwards into it and draw the straps over the top of your head as far
as they will go. See that the straps are properly adjusted and leave them so.
To remove the mask, insert the thumb under the buckle at the back of your head and then pull it forward over
the top of your head so that the mask is lowered downwards from the face.
After the mask has been used you will find that it is wet on the inside with moisture from the breath. This
should be wiped off with a soft dry cloth and the mask allowed to dry before it
is put away in its box. Do not try to dry it by applying heat.
The contents of the container do not deteriorate either with age or with wearing the mask when gas is not
present. But if you suspect any flaw in your gas mask you should inform your local Air Raid Warden.
It is a good thing to get out your gas mask occasionally and put it on, so as to get
used to wearing it, and if you take the simple precautions set out above you
will ensure that it is always ready for your protection.